When you run a recovery plan, Site Recovery Manager migrates all virtual machines in the recovery plan to the recovery site. Site Recovery Manager attempts to shut down the corresponding virtual machines on the protected site.
About this task
A recovery plan makes significant alterations in the configurations of the protected and recovery sites and it stops replication. Do not run any recovery plan that you have not tested. Reversing these changes might cost significant time and effort and can result in prolonged service downtime.
To use forced recovery, you must first enable this function. You enable forced recovery by enabling the recovery.forceRecovery setting as described in Change Recovery Settings.
Ensure that you have configured full inventory mappings. If you have only configured temporary placeholder inventory mappings and you run a planned migration with the Enable vMotion of eligible VMs option, planned migration fails, even though both sites are running.
To use the Enable vMotion of eligible VMs option with planned migration, enable vMotion on the virtual machines. For instructions about enabling vMotion on virtual machines, see Enable vSphere vMotion for Planned Migration.
- In the vSphere Web Client, select , and select a recovery plan.
- Right-click the recovery plan and select Run.
- Review the information in the confirmation prompt, and select I understand that this process will permanently alter the virtual machines and infrastructure of both the protected and recovery datacenters.
- Select the type of recovery to run.
Recovers virtual machines to the recovery site when both sites are running. If errors occur on the protected site during a planned migration, the planned migration operation fails. If your array supports stretched storage, select the Enable vMotion of eligible VMs check box.
Recovers virtual machines to the recovery site if the protected site experiences a problem. If errors occur on the protected site during a disaster recovery, the disaster recovery continues and does not fail.
- (Optional) Select the Forced Recovery - recovery site operations only check box.
This option is available if you enabled the forced recovery function and you selected Disaster Recovery.
- Click Next.
- Review the recovery information and click Finish.
When you run planned migration of a recovery plan that contains a storage policy protection group, Site Recovery Manager checks that the protection groups are synchronized on both of the protected and recovery sites before it runs the recovery plan. This check happens when you click Finish. If the protection group is synchronized on both sites, the planned migration begins. If the protection group is not synchronized at both sites, you see the error The peer site has not finished synchronizing changes to protection group.
If you see this error, dismiss the error message and click Finish again. If the synchronization has completed, the planned migration begins.
If the error persists, cancel the planned migration, wait a short time, and attempt to run the planned migration again.
- Click the Monitor tab and click Recovery Steps.
The Recovery Steps tab displays the progress of individual steps. The Recent Tasks area reports the progress of the overall plan.