On the Access Point appliance, you must enable RADIUS authentication, enter the configuration settings from the RADIUS server, and change the authentication type to RADIUS authentication.

Prerequisites

  • Verify that the server to be used as the authentication manager server has the RADIUS software installed and configured. Set up the RADIUS server and then configure the RADIUS requests from Access Point. Refer to your RADIUS vendor's setup guides for information about setting up the RADIUS server.

The following RADIUS server information is required.

  • IP address or DNS name of the RADIUS server.

  • Authentication port numbers. Authentication port is usually 1812.

  • Authentication type. The authentication types include PAP (Password Authentication Protocol), CHAP (Challenge Handshake Authentication Protocol), MSCHAP1, MSCHAP2 (Microsoft Challenge Handshake Authentication Protocol, versions 1 and 2).

  • RADIUS shared secret that is used for encryption and decryption in RADIUS protocol messages.

  • Specific timeout and retry values needed for RADIUS authentication

Procedure

  1. In the admin UI Configure Manually section, click Select.
  2. In the General Settings Authenticating Settings section, click Show.
  3. Click the gearbox in the RADIUS line.

    Option

    Action

    Enable RADIUS

    Change NO to YES to enable RADIUS authentication.

    Name*

    The name is radius-auth

    Authentication type*

    Enter the authentication protocol that is supported by the RADIUS server. Either PAP, CHAP, MSCHAP1, OR MSCHAP2.

    Shared secret*

    Enter the RADIUS shared secret.

    Number of Authentication attempts allowed *

    Enter the maximum number of failed login attempts when using RADIUS to log in. The default is three attempts.

    Number of attempts to RADIUS server*

    Enter the total number of retry attempts. If the primary server does not respond, the service waits for the configured time before retrying again.

    Server Timeout in Seconds*

    Enter the RADIUS server timeout in seconds, after which a retry is sent if the RADIUS server does not respond.

    Radius Server Host name *

    Enter the host name or the IP address of the RADIUS server.

    Authentication Port*

    Enter the Radius authentication port number. The port is usually 1812.

    Realm Prefix

    (Optional) The user account location is called the realm.

    If you specify a realm prefix string, the string is placed at the beginning of the user name when the name is sent to the RADIUS server. For example, if the user name is entered as jdoe and the realm prefix DOMAIN-A\ is specified, the user name DOMAIN-A\jdoe is sent to the RADIUS server. If you do not configure these fields, only the user name that is entered is sent.

    Realm Suffix

    (Optional) If you configure a realm suffix, the string is placed at the end of the user name. For example, if the suffix is @myco.com, the user name jdoe@myco.com is sent to the RADIUS server.

    Name iD Suffix

    Enter the nameId that enables View to provide a True SSO experience.

    Login page passphrase hint

    Enter the text string to display in the message on the user login page to direct users to enter the correct Radius passcode. For example, if this field is configured with AD password first and then SMS passcode, the login page message would read Enter your AD password first and then SMS passcode. The default text string is RADIUS Passcode.

    Enable secondary server

    Change NO to YES to configure a secondary RADIUS server for high availability. Configure the secondary server information as described in step 3.

  4. Click Save.