You can configure SNMPv3 in the Unified Access Gateway Admin UI. SNMPv3 has enhanced security features such as authentication and privacy. Unified Access Gateway continues to support SNMPv1 and SNMPv2c, which are the default versions. You can also configure SNMPv3 through PowerShell deployment by adding certain SNMPv3-related settings in the INI file.

If you have deployed Unified Access Gateway through PowerShell, enabled SNMP, but not configured SNMPv3 settings, then by default SNMPv1 and SNMPV2c versions are used.

You can also configure SNMPv3 settings using PowerShell. For more information about these parameters, see Using PowerShell to Deploy the Unified Access Gateway Appliance.

Procedure

  1. In the Admin UI's Configure Manually section, click Select.
  2. In the Advanced Settings section, click the System Configuration gearbox icon.
  3. Turn on the Enable SNMP toggle to enable the SNMP service.
    Note: You must enable SNMP before configuring Tunnel. If you enable SNMP after configuring Tunnel, you must re-save the Tunnel settings for the SNMP settings to take effect.
  4. Select the SNMP Version as SNMPv3.
  5. Enter the SNMPv3 USM User name.
  6. Enter the SNMP Engine ID.

    This value is unique for each Unified Access Gateway appliance.

    The maximum length of the engine ID is limited to 27 characters.

  7. Select the SNMPv3 Security Level.
  8. Depending on the security level selected in the previous step, perform the following actions:
    Security Level Actions
    No Auth, No Priv

    (No Authentication, No Privacy)

    		 Click Save.

    No further actions are necessary.
    Auth, No Priv

    (Authentication, No Privacy)
    1. Select the SNMPv3 Auth Algorithm.
    2. Enter the SNMPv3 Auth Password.

      Password must be at least 8 characters long.

    3. Confirm Auth Password entered in the previous step.
    4. Click Save.
    Auth, Priv

    (Authentication, Privacy)
    1. Select the SNMPv3 Auth Algorithm.

      The supported values are as follows: MD5, SHA, SHA-224, SHA-256, SHA-384, and SHA-512.

    2. Enter the SNMPv3 Auth Password.

      Password must be at least 8 characters long.

    3. Confirm the Auth Password entered in the previous step.
    4. Select the SNMPv3 Privacy Algorithm.

      The supported values are DES and AES.

    5. Select the SNMPv3 Privacy Password.

      Password must be at least 8 characters long.

    6. Confirm Privacy Password entered in the previous step.
    7. Click Save.