You can change or customize the settings following initial deployment using the Avi Load Balancer Controller’s web interface.

Navigate to the Avi Load Balancer Controller on your browser.

Note:

While the system is booting up, a blank web page or a 503 status code may appear. Wait for about 5 to 10 minutes and then follow the instructions below for the setup wizard.

The steps are similar to the ones mentioned for write access in the above section.

In the cloud setup, navigate to Infrastructure > Clouds. Click CREATE and select No Orchestrator option from the drop-down menu.

Follow the similar steps mentioned in the above section for write access.

To verify vCenter resources discovery by Avi Load Balancer Controller, navigate to Infrastructure > Clouds. Check for the cloud status. The discovery status should be 100% complete.

After creating the cloud, the cloud status will turn yellow indicating the discovery of vCenter objects in progress. The status signal will turn green after the discovery is finished. If you click on the status signal, it will show the networks subnet overlapping information along with hosts information.

The host information is available if content library is not configured in cloud configuration.

If the management and pool networks use DHCP, then the deployment procedure is complete. If static address allocation is used, then an additional step as explained at Configuring IP address pools for networks is required.