This section describes how to deploy Controller using CSP UI.

The following are the steps to deploy the Controller using the CSP UI:

Procedure

  1. Navigate to Configuration > Services.
  2. Click +.
    Note:

    The disk size of any CSP image cannot be changed. To avoid deletion and recreation of the entire configuration, have an informed idea of deployment.

  3. Specify the Service Name.
  4. Select the host from the Target Host Name list. In version CSP 2.1.0, on a CSP cluster, you can select the HA host name.
  5. Leave the VNF Management IP field blank. This is set using the Day Zero Config.
  6. Select the controller.qcow2 image from the Image Name list.
  7. Select the Controller metadata file from the Day Zero Config drop-down menu.
  8. Set the resource values for Disk, CPU and RAM.
  9. Click + to add a vNIC and connect it to enp1s0f0 in access mode.
    Note:

    If the management network is on a different VLAN, specify the VLAN number in the VLAN field, and click on VLAN Tagged to enable tagging.

  10. Specify a password for the console login using VNC, if required.
  11. Click Deploy.