You can update the AV signature pack by using the RepCLI command.


  1. Log into the machine with a user account that matches the AD User or Group SID that was configured at the time of sensor install.
  2. Open a command prompt window with administrative privileges.
  3. Change the directory to C:\Program Files\Confer.
  4. Type the following command: repcli UpdateAvSignature


If the command is successful, the message The request of AV signature update has been accepted displays on the command line.

Note: Active Directory-based SID authentication is not required to run the repcli UpdateAVSignature command. For more information about RepCLI, see Managing Sensors by using RepCLI in the User Guide.