Perform a Command Line Installation of a macOS Sensor for FIPS Compliance

Use the following command to install a 3.6+ macOS sensor with FIPS compliance.

FIPS is disabled by default. You can enable FIPS mode by using the --enable-fips command line option. For example:

Prerequisites

For full instructions on installing macOS sensors through the command line, see macOS Sensor Command Line Install.

♦ Run the following command:
Note: The following command is an example using the default directory structure and assumes that the terminals working directory contains the unattended install script, and that the parent contains the installer pkg.
```
sudo ./cbcloud_install_unattended.sh --enable-fips -i ../CBCloud\ Install.pkg -c "${code}"
```