By using route advertisement, you can create a fully routed network environment in an organization virtual data center (VDC).

Note: If you are using IP spaces, route advertisement is managed at the organization VDC network level. When you create an IP space, configuring its network topology includes allowing route advertisement for the routed networks associated with the IP space from the edge gateway to the provider gateway. See Enable Route Advertisement for an IP Space and Create a Routed Organization VDC Network.
You can decide which of the network subnets that are attached to the edge gateway backed by NSX to advertise to the dedicated provider gateway.

If a subnet is not added to the advertisement filter, the route to it is not advertised to the provider gateway and the subnet remains private.

Note: VMware Cloud Director advertises any organization VDC network that falls within the advertised route. Because of that, you do not need to create a filter for each subnet that is part of an advertised network.

Route advertisement is automatically configured on the NSX edge gateway.

VMware Cloud Director supports automatic route redistribution when you use route advertisement on an NSX edge gateway. Route redistribution is automatically configured on the tier-0 logical router which represents the dedicated provider gateway.

Prerequisites

  • Verify that the system administrator dedicated a provider gateway that used IP blocks to an NSX edge gateway in your organization.
  • Verify that you are an organization administrator or you are assigned a role that includes an equivalent set of rights.

Procedure

  1. From the primary left navigation panel, select Networking and from the page top navigation bar, select Edge Gateways.
  2. Click the edge gateway.
  3. Under Routing, click Route Advertisement and Edit.
  4. To add a subnet to be advertised, click Add.
  5. Add an IPv4 or IPv6 subnet.
    Use the format network_gateway_IP_address/ subnet_prefix_length, for example, 192.167.1.1/24.