HCX provides options for Network Extension upgrade or redeployment that help to minimize service downtime and disruptions to on-going L2 traffic.
The Network Extension appliance is a critical component of many HCX deployments, not only during migration but post migration as extended networks continue to be used after migration in a hybrid environment. HCX operations using extended networks can be impacted during Network Extension appliance upgrades or when a change to the HCX Compute Profile or Service Mesh requires redeploying the Network Extension appliance.
Network Extension appliances are available for In-Service or Standard (default) upgrade.
- A new appliance is provisioned at the source and destination site.
- New Uplink and Management IP addresses are reserved for each new Network Extension appliance.
- NICs on the new appliances are connected, including NICs for extended networks, except the NIC connection state is flagged as Down.
- Secure tunnel connections are established between sites.
- Old appliance Bridge NICs are disconnected. New Appliances Bridge NICs are connected.
- The old appliance is deleted. IP addresses used for the old appliance are released and made available.
With a Standard upgrade or redeployment of the Network Extension appliance, the new appliances use the same Uplink and Management IP addresses as the existing appliance. Using the same IP addresses means that HCX must disconnect the existing appliance so that the IP addresses are available for the new appliance. In this case, tunnel connections are established only after switchover happens, requiring 30 seconds or more to reestablish data traffic across extended networks.
Network Extension upgrade or redeployment operations display a pop-up window with the option for In-Service or Standard mode deployment.
For more information about upgrading HCX appliances, see Updating VMware HCX.
- Existing HCX-NET-EXT appliances must be running HCX 4.0 or later. This feature cannot be used while upgrading from HCX 3.5.x to HCX 4.0.
- Appliance tunnels must be in Up state as shown by navigating to . Appliances with Down or Degraded tunnels are not supported.
- HCX Manager must be able to reach HCX-NET-EXT appliances via the management network.
- For each Network Appliance, free IP addresses are available in both the HCX Management and Uplink Network profile address pools during the Upgrade or Redeploy process. For example, upgrading 3 Network Extension appliances at the same time requires 3 available Management IP addresses and 3 available Uplink IP addresses. Once the process completes, the IP addresses used by the previous appliance are released.
- Select the Network Extension appliances for update or deployment.
- Click Update or Redeploy.
The selections that appears depends on the operation being performed. The option for selecting Standard or In-Service mode can appear when updating or redeploying the Network Extension appliances from either the Service Mesh View Appliances or View Topology window, or from the Service Mesh Edit or Resync window. The following are examples of the update and deployment windows.
- Depending on the operation, click OK or Redeploy.
What to do next
Verify the Update or deployment task by navigating to. After the task completes, check that the tunnel status is Up.