You use different approaches to reinstall View Agent on a Linux virtual machine, depending on whether you use an existing Horizon 6 for Linux configuration or reinstall with a fresh configuration.

About this task

You can reinstall View Agent with an existing configuration if the Horizon 6 for Linux configuration files are present on the virtual machine and the machine is registered in View Connection Server.

If either the configuration files were removed from the machine or the registered machine name was removed from View Connection Server, you must ensure that both the local configuration files and the registered machine name in View Connection Server are removed. You can then perform a fresh installation of View Agent with a new configuration.

Prerequisites

  • Verify whether the Horizon 6 for Linux configuration files are present on the machine.

    /etc/vmware/viewagent-machine.cfg 
    /etc/vmware/viewagent-config.txt 
    /etc/vmware/jms 
    /etc/vmware/ssl 
    
  • Verify whether the Linux virtual machine is registered in View Connection Server. In View Administrator, select View Configuration > Registered Machines and select the Others tab.

  • If the configuration files and registered machine name were removed, familiarize yourself with the steps for performing a fresh installation of View Agent. See Install View Agent on a Linux Virtual Machine.

Procedure

  • To reinstall with an existing Horizon 6 for Linux configuration, you can run the View Agent installation script without parameters.
    sudo ./install_viewagent.sh

    The View Agent installer reuses the existing configuration files and machine registration in View Connection Server. The installer does not register the machine again.

  • To reinstall with a new Horizon 6 for Linux configuration, run the View Agent installation script with the required parameters.

    The installation steps are the same as those in a fresh installation. The installer registers the machine with View Connection Server.