You must run the bootstrap shell script a second time to install the DaaS software.

Procedure

  1. Run the bootstrap shell script:
    sudo /usr/local/desktone/scripts/bootstrap.sh

    System reboots.

  2. SSH into the system again and wait for the log file to appear and watch desktone.log file:
    tail  –f  /var/log/desktone/desktone.log

    The system is up when you see a message similar to this in the log:

    Appliance deployed flag set to started
  3. Open a browser and log into https://172.16.109.xxx/service, or whatever IP you supplied for “IP for eth0 (SP)” above.
    Note:

    It might take five minutes for the appliance to start after reboot. Because the node is not configured until the reboot cycle completes, you can disregard any error messages displayed on the console.