This section shows the steps to perform the initial configuration of the NSX Advanced Load Balancer Controller using its deployment wizard. You can change or customize settings following initial deployment using the NSX Advanced Load Balancer Controller web interface.

Note:

The NSX-T cloud is not a part of the deployment wizard. Therefore, select No Orchestrator as the integration option.

Procedure

  1. Navigate to the NSX Advanced Load Balancer Controller IP on your browser.

    While the system is booting up, a 503 status code or a page with following message will appear, “Controller is not yet ready. Please try again after a couple of minutes”. Wait for about 5 to 10 minutes, refresh the page and then follow the instructions below for the setup wizard.

  2. Enter the User Name, Password, Confirm Password and optionally the Email Address.
  3. Enter the DNS and NTP server information.
  4. Configure the Email/SMTP information.
  5. Under Orchestrator Integration, select No Orchestrator.
  6. Select No under Support Multiple Tenants.