You can bridge a given logical switch to a single VLAN with one active bridge instance. One logical router can have multiple bridging instances, however, the same VXLAN and VLAN cannot connect to more than one bridge instance.
You can use a logical switch to participate in both distributed logical routing and layer 2 bridging. Therefore, the traffic from the bridged logical switch does not need to flow through the centralized Edge VM. The traffic from the bridged logical switch can flow to the physical VLAN through the L2 bridge instance. The bridge instance gets enabled on the ESXi host where the DLR control VM is running.
For more information about L2 bridging in NSX, see the "NSX Distributed Routing and Layer 2 Bridging Integration" section in the NSX Network Virtualization Design Guide at https://communities.vmware.com/docs/DOC-27683.
- An NSX logical router must be deployed in your environment.
- You cannot use a universal logical router to configure bridging, and you cannot add a bridge to a universal logical switch.
- Log in to the vSphere Web Client.
- Click Networking & Security and then click NSX Edges.
- Double-click the logical router that you want to use for bridging.
Note: The bridge instance must be created in the same routing instance to which the VXLAN is connected. One bridge instance can have one VXLAN and one VLAN, and the VXLAN and VLAN cannot overlap. The same VXLAN and VLAN cannot connect to more than one bridge instance.
- Click Manage and then click Bridging.
The logical switch that is being used as a router will state Routing Enabled.
- Click the Add () icon.
- Type a name for the bridge.
- Select the logical switch that you want to create a bridge for.
- Select the distributed virtual port group to which you want to bridge the logical switch.
- Click OK.
- Click OK again in the Add Bridge window.
- Click Publish for changes to the bridging configuration to take effect.