When a tier-1 logical router advertises routes to a tier-0 logical router, the routes are listed in the tier-0 router's routing table as NSX-T Data Center static routes.


  1. On the NSX Edge, run the get logical-routers command to find the VRF number of the tier-0 service router.
    nsx-edge-1> get logical-routers
    Logical Router
    UUID        : 736a80e3-23f6-5a2d-81d6-bbefb2786666
    vrf         : 0
    type        : TUNNEL
    Logical Router
    UUID        : 421a2d0d-f423-46f1-93a1-2f9e366176c8
    vrf         : 5
    type        : SERVICE_ROUTER_TIER0
    Logical Router
    UUID        : f3ce9d7d-7123-47d6-aba6-45cf1388ca7b
    vrf         : 6
    type        : DISTRIBUTED_ROUTER
    Logical Router
    UUID        : c8e64eff-02b2-4462-94ff-89f3788f1a61
    vrf         : 7
    type        : SERVICE_ROUTER_TIER1
    Logical Router
    UUID        : fb6c3f1f-599f-4421-af8a-99692dff3dd4
    vrf         : 8
    type        : DISTRIBUTED_ROUTER
  2. Run the vrf <number> command to enter the tier-0 service router context.
    nsx-edge-1> vrf 5
  3. On the tier-0 service router, run the get route command and make sure the expected routes appear in the routing table.
    Notice that the NSX-T Data Center static routes (ns) are learned by the tier-0 router because the tier-1 router is advertising routes.
    nsx-edge1(tier0_sr)> get route
    Flags: c - connected, s - static, b - BGP, ns - nsx_static
    nc - nsx_connected, rl - router_link, t0n: Tier0-NAT, t1n: Tier1-NAT
    Total number of routes: 7
    b        [20/0]        via
    rl      [0/0]         via
    c       [0/0]         via
    ns       [3/3]         via
    ns       [3/3]         via
    c     [0/0]         via