DHCP (Dynamic Host Configuration Protocol) allows clients to automatically obtain network configuration, such as IP address, subnet mask, default gateway, and DNS configuration, from a DHCP server.

You can create DHCP servers to handle DHCP requests and create DHCP relay services to relay DHCP traffic to external DHCP servers. However, you should not configure a DHCP server on a logical switch and also configure a DHCP relay service on a router port that the same logical switch is connected to. In such a scenario, DHCP requests will only go to the DHCP relay service.

If you configure DHCP servers, to improve security, configure a DFW rule to allow traffic on UDP ports 67 and 68 only for valid DHCP server IP addresses.

Note: A DFW rule that has Logical Switch/Logical Port/NSGroup as the source, Any as the destination, and is configured to drop DHCP packets for ports 67 and 68, will fail to block DHCP traffic. To block DHCP traffic, configure Any as the source as well as the destination.

In this release, the DHCP server does not support guest VLAN tagging.