You can configure multicast on a tier-0 gateway and optionally on a tier-1 gateway for an IPv4 network to send the same multicast data to a group of recipients. In a multicast environment, any host, regardless of whether it is a member of a group, can send to a group. However, only the members of a group will receive packets sent to that group.
- PIM Sparse Mode with IGMPv2.
- No Rendezvous Point (RP) or Bootstrap Router (BSR) functionality on NSX-T. However, RP information can be learned via PIM Bootstrap Messages (BSMs). In addition, multiple Static RPs can be configured.
When a Static RP is configured, it serves as the RP for all multicast groups (224/4). If candidate RPs learned from BSMs advertise candidacy for the same group range, the Static RP is preferred. However, if candidate RPs advertise candidacy for a specific group or range of groups, they are preferred as the RP for those groups.
- The Reverse Path Forwarding (RPF) check for all multicast-specific IPs (senders of data traffic, BSRs, RPs) requires that a route to each of them exists.
- The RPF check requires a route to each multicast-specific IP with an IP address as the next hop. Reachability via device routes, where the next hop is an interface index, is not supported.
- Both tier-0 and tier-1 gateways are supported. To enable multicast on a tier-1 gateway, an Edge cluster must be selected and the tier-1 gateway must be linked to a tier-0 gateway that also has multicast enabled.
- All uplinks on a tier-0 gateway are supported.
- Multiple Static RPs with discontinuous group ranges are supported.
- IGMP local groups on uplink interfaces are supported.
- PIM Hello Interval and Hold Time are supported.
- Active-Cold Standby only is supported.
- The NSX Edge cluster can be in active-active or active-standby mode. When the cluster is in active-active mode, two of the cluster members will run multicast in active-cold standby mode. You can run the CLI command get mcast high-availability role on each Edge to identify the two nodes participating in multicast. Also note that since unicast reachability to NSX-T in an active-active cluster is via ECMP, it is imperative that the northbound PIM router selects the ECMP path that matches a PIM neighbor to send PIM Join/Prune messages to NSX-T. In this way it will select the active Edge which is running PIM.
- East-west multicast replication: up to 4 VTEP segments for maximum replication efficiency.
- ESXi host and NSX Edge only (KVM not supported).
- Layer 2 bridge attached to a downlink segment not supported.
- Edge Firewall services are not supported for multicast. Distributed Firewall is supported.
- Multi-site (NSX Federation) not supported.
- Multi-VRF not supported.
Multicast Configuration Prerequisites
- Acquire a multicast address range from your network administrator. This will be used to configure the Multicast Replication Range when you configure multicast on a tier-0 gateway (see Configure Multicast).
- Enable IGMP snooping on the layer 2 switches to which GENEVE participating transport nodes are attached. If IGMP snooping is enabled on layer 2, IGMP querier must be enabled on the router or layer 3 switch with connectivity to multicast enabled networks.
Multicast Configuration Steps
- Create an IGMP profile. See Create an IGMP Profile.
- Optionally create a PIM profile to configure a Static Rendezvous Point (RP). See Create a PIM Profile.
- Configure a tier-0 gateway to support multicast. See Add a Tier-0 Gateway and Configure Multicast.
- Optionally configure tier-1 gateways to support multicast. See Add a Tier-1 Gateway.