In a network, latency can accumulate at multiple endpoints in the data path. As a network administrator, you need the ability to monitor the latency of a network to diagnose and troubleshoot performance bottlenecks in the network.

The following network latency statistics can be measured on host transport nodes:
  • pNIC to vNIC
  • vNIC to pNIC
  • vNIC to vNIC
  • VTEP to VTEP
In NSX-T Data Center, the following limitations apply to measuring latency statistics:
  • Only ESXi host transport nodes are supported for measuring network latency in the data plane.
  • KVM hosts and edge transport nodes are not supported.
  • On VLAN segments, network latency is measured only when the two vNICs belong to VMs on the same ESXi host.
  • When the VMs are attached to separate segments, network latency is measured only when the data traffic is routed through the distributed router (DR) instance on the ESXi host transport nodes. If the data traffic is routed through the DR instance on the edge transport nodes, network latency is not measured.
  • Enhanced networking stack (ENS) does not support vNIC to pNIC, pNIC to vNIC, and vNIC to vNIC latency.
  • Latency measurement is not supported when an east-west network traffic protection is configured using partner service VMs. Latency monitoring is disabled on the ports of service virtual machine (SVMs) and guest VMs.

You can export the latency data to external network performance monitoring tools and run analytics on the data. The external monitoring tools are also called collectors. By using a collector, you can achieve greater network visibility, optimize network performance, and identify the endpoints in the data path that cause a significant latency in the network.

After the hosts are configured to measure network latency statistics, the network operations agent (netopa) on the hosts periodically polls the data plane. When latency data is available, the agent exports the data at preconfigured intervals to the external collectors.

Note:
  • The netopa agent can export the network latency statistics only to vRealize Network Insight (vRNI). Other collector tools are not supported currently.
  • You can configure ESXi hosts to measure network latency statistics only by using the NSX REST APIs.

The following support matrix summarizes the transport nodes and collectors that are supported for various network latency statistics.

Table 1. Support Matrix
Network Latency Statistics Starting in NSX-T Data Center Version Supported Transport Nodes Supported Collectors Comments

VTEP to VTEP

 2.5

ESXi hosts

vRNI 5.0 or later

pNIC to vNIC

vNIC to pNIC

vNIC to vNIC

 3.0

ESXi hosts

vRNI 5.3

 Support for exporting statistics to vRNI 5.3 is available starting in NSX-T Data Center 3.0.2.

You can measure network latency statistics for both standalone ESXi hosts and ESXi hosts that are a part of the vCenter Server cluster. However, network latency statistics from only vCenter-managed ESXi hosts can be exported to vRNI. vRNI does not support collecting latency statistics from standalone ESXi hosts that are not managed by a vCenter Server.

pNIC to vNIC and vNIC to pNIC Latency

When pNIC latency measurement is enabled on a host transport node, vNIC to pNIC latency and pNIC to vNIC latency are computed for each vNIC on the host transport node.


Diagram shows pNIC to vNIC and vNIC to pNIC latency on a single host.

pNIC to vNIC and vNIC to pNIC latency statistics are exported to the external collector in the following format:

Endpoint1, Endpoint2, Max, Min, Avg
Where:
  • Endpoint1, Endpoint2 can either be the virtual interface ID (VIF ID) or the name of the physical adapter on an ESXi host (vmnic).
  • Max, Min, and Avg represent the maximum, minimum, and average latency values between the two endpoints in microseconds.

vNIC to vNIC Latency

This latency represents the time taken by the data packet to travel from the source vNIC to the destination vNIC either on the same ESXi host or different ESXi hosts. If the vNICs are on different ESXi hosts, only GENEVE encapsulation protocol is supported in the overlay tunnel between the hosts.


Diagram shows vNIC to vNIC latency between VMs on the same host and on different hosts.
vNIC to vNIC network latency is computed as follows:
  • When the source VNIC1 on VM1 and the destination VNIC2 on VM2 are on the same host, a single-trip latency is calculated for each trip and exported to the collector. In other words, latency for each trip VNIC1 to VNIC2 and VNIC2 to VNIC1 is computed separately.
  • When the source VNIC1 on VM1 and the destination VNIC2 on VM2 are on different hosts, total round-trip latency is calculated, and only a single latency value is exported to the collector. If there is no return traffic from VNIC2 to VNIC1, no network latency is exported to the collector.
Note: NSX-T Data Center calculates the vNIC to vNIC latency between hosts directly by using the timestamps in the GENEVE encapsulated packets. You do not have to enable pNIC latency measurement on the host and the VTEP to VTEP latency. The pNIC to vNIC, vNIC to pNIC, and VTEP to VTEP statistics are independent of the vNIC to vNIC statistic.

vNIC to vNIC latency statistics are exported to the external collector in the following format:

VIF1, VIF2, Max, Min, Avg
Where:
  • VIF1, VIF2 represent the virtual interfaces or the vNICs.
  • Max, Min, and Avg represent the maximum, minimum, and average latency values between the two vNICs in microseconds.

VTEP to VTEP Latency

This latency represents the total round-trip time taken by the data packet to travel from the source VTEP to the destination VTEP. To measure VTEP to VTEP latency, you must enable latency in the transport zone profile.


Diagram shows VTEP to VTEP latency between hosts.

To calculate the VTEP to VTEP latency between ESXi hosts, Bidirectional Flow Detection (BFD) protocol is used. NSX-T Data Center extends the BFD protocol with timestamps in the payload to support latency computation between the VTEPs. BFD packets are transmitted at regular intervals in each tunnel between the hosts to compute the VTEP to VTEP latency.