The tier-1 logical router must be connected to the tier-0 logical router to get the northbound physical router access.

Prerequisites

  • Verify that the logical switches are configured. See Create a Logical Switch.

  • Verify that an NSX Edge cluster is deployed to perform network address translation (NAT) configuration. See the NSX-T Installation Guide.

  • Familiarize yourself with the tier-1 logical router topology. See Configuring the Tier-1 Logical Router.

Procedure

  1. From your browser, log in to an NSX Manager at https://nsx-manager-ip-address.
  2. Select Routing from the navigation panel.
  3. Click Add and select Tier-1 Router.
  4. Assign a name for the logical router.
  5. (Optional) : Select a tier-0 logical router to connect to this tier-1 logical router.

    If you do not yet have any tier-0 logical routers configured, you can leave this field blank for now and edit the router configuration later.

  6. (Optional) : Select a failover mode.

    Option

    Description

    Preemptive

    If the preferred node fails and recovers, it will preempt its peer and become the active node. The peer will change its state to standby. This is the default option.

    Non-preemptive

    If the preferred node fails and recovers, it will check if its peer is the active node. If so, the preferred node will not preempt its peer and will be the standby node.

  7. (Optional) : Select an edge cluster to connect to this tier-1 logical router.

    If the tier-1 logical router is going to be used for NAT configuration, it must be connected to an NSX Edge cluster. If you do not yet have any edge clusters configured, you can leave this field blank for now and edit the router configuration later.

  8. Click Save.

    In the NSX Manager UI, the new logical router is a clickable link.

Results

If this logical router supports more than 5000 VMs, you must run the following commands on each node of the edge cluster to increase the size of the ARP table.

   set debug-mode
   set dataplane neighbor max-arp-logical-router 10000

You must re-run the commands after a dataplane restart or a node reboot because the change is not persistent.

What to do next

Create downlink ports for your tier-1 logical router. See Add Downlink Ports for the Tier-1 Logical Router.