NSX Manager and NSX Controller can be installed as KVM VMs. In addition, KVM can be used as the hypervisor for NSX-T transport nodes.
KVM guest VM management is beyond the scope of this guide. However, here are some simple KVM CLI commands to get your started.
To manage your guest VMs in the KVM CLI, you can use virsh commands. Following are some common virsh commands. Refer to KVM documentation for additional information.
# List running virsh list # List all virsh list --all # Control instances virsh start <instance> virsh shutdown <instance> virsh destroy <instance> virsh undefine <instance> virsh suspend <instance> virsh resume <instance> # Access an instance's CLI virsh console <instance>
In the Linux CLI, the ifconfig command shows the vnetX interface, which represents the interface created for the guest VM. If you add additional guest VMs, additional vnetX interfaces are added.
ifconfig ... vnet0 Link encap:Ethernet HWaddr fe:54:00:b0:a0:6d inet6 addr: fe80::fc54:ff:feb0:a06d/64 Scope:Link UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 RX packets:13183 errors:0 dropped:0 overruns:0 frame:0 TX packets:181524 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:500 RX bytes:4984832 (4.9 MB) TX bytes:29498709 (29.4 MB)