You must configure the the OVSDB manager table on the ToR physical switch to connect the hardware gateway to the NSX Controller.
About this task
The Controller passively listens to the connection attempt from ToR. Therefore, the hardware gateway must use the OVSDB manager table to initiate connection.
- Use the commands that apply to your environment to connect the hardware gateway to the NSX Controller.
Sample commands to connect hardware gateway and NSX Controller.
prmh-nsx-tor-7050sx-3#enable prmh-nsx-tor-7050sx-3#configure terminal prmh-nsx-tor-7050sx-3(config)#cvx prmh-nsx-tor-7050sx-3(config-cvx)#service hsc prmh-nsx-tor-7050sx-3(config-cvx-hsc)#manager 172.16.2.95 6640 prmh-nsx-tor-7050sx-3(config-cvx-hsc)#no shutdown prmh-nsx-tor-7050sx-3(config-cvx-hsc)#end
- Set the OVSDB manager table on the hardware gateway.
- Set the OVSDB port number value as 6640.
- (Optional) : Verify that the hardware gateway is connected to the NSX Controller through the OVSDB channel.
Check that the connection status is UP.
Ping the VM1 and VLAN 160 to verify that the connection succeeds.
- (Optional) : Verify that the hardware gateway is connected to correct NSX Controller.
- Log in to the vSphere Web Client.
- Select .