You can enable the SNMP settings and configure destination receivers to send traps that are critical, high, or informational.
- Log in to the vSphere Web Client.
- Select .
- Select an NSX Manager IP address.
- Select the tabs.
- Click Edit to configure the SNMP settings.
Sends out SNMP trap.
By default, this option is disabled.
Predefined set of groups for some system events that are used to aggregate the events that are raised. By default, this option is enabled.
For example, if a system event belongs to a group, the trap for these grouped events are withheld. Every five minutes a trap is sent out detailing the number of system events that have been received from the NSX Manager. The fewer traps being sent out save the SNMP receiver resources.
Configure up to four receivers for traps to be sent out to.
You must complete the following sections when you add an SNMP receiver.
Receiver Address - IP address or the fully qualified domain name of the receiver host.
Receiver Port - SNMP receiver default UDP port is 162.
Community String - Information to be sent out as part of the notification trap.
Enabled - Indicates whether this receiver is sending a trap.
- Click OK.
The SNMP service is enabled and traps are sent out to the receivers.
What to do next
Check whether the SNMP configuration works. See Verify SNMP Trap Configuration.