This scenario describes typical tasks used to configure a hardware gateway switch with an NSX deployment. The sequence of tasks show how to connect the virtual machine VM1 to the physical server and to connect the WebService logical switch to the VLAN-Server VLAN 160 using the hardware gateway.
The sample topology shows that virtual machine VM1 and VLAN-Server are configured with an IP address in the subnet 10. VM1 is attached to WebService logical switch. The VLAN-Server is attached to VLAN 160 on the physical server.
In a cross-vCenter NSX environment, hardware gateway switch configurations are only supported on the primary NSX Manager. Hardware gateway switches must be bound to non-universal logical switches. Hardware gateway configurations are not supported on secondary NSX Managers.
Read the vendor documentation to meet the physical network requirements.
Verify that you meet the NSX system and hardware requirements for hardware gateway configuration. See System Requirements for NSX Data Center for vSphere.
Verify that the logical networks are set up properly. See the NSX Installation guide.
Verify that the transport parameter mappings in the VXLAN are accurate. See the NSX Installation guide.
Retrieve the vendor certificate for your hardware gateway.
Verify that the VXLAN port value is set to 4789. See Change VXLAN Port.