State Synchronization of Tier-1 Gateways

Connection information of the traffic running on a given tier-1 SR (Service Router) is synchronized to its peer tier-1 SR in active-standby or stateful active-active HA modes. Note that stateful active-active mode is only available starting with NSX 4.0.1.1.

Note: State synchronization is not supported for TLS Inspection and IDPS.

In NSX 4.0.0.1, note the following about state synchronization:

• State synchronization is supported for Gateway Firewall, Identity Firewall, NAT, IPSec VPN, DHCP, FQDN analysis, and URL filtering.
• If new sessions were going through a tier-1 SR just before a failover, it might happen that those sessions were not synchronized on the associated tier-1 SR and potentially affect the traffic for those sessions.

Starting with NSX 4.0.1.1, note the following about state synchronization:

• In active-standby mode, state synchronization is supported for Gateway Firewall, Identity Firewall, NAT, IPSec VPN, DHCP, FQDN analysis, and URL filtering.
• In active-active mode, state synchronization is supported for Gateway Firewall, Identity Firewall, NAT, FQDN analysis, and URL filtering. FQDN analysis is only supported with a single sub-cluster. IPSec VPN is not supported.
• If new sessions were going through a tier-1 SR just before a failover, it might happen that those sessions were not synchronized on the associated tier-1 SR and potentially affect the traffic for those sessions.