For the Pull Activation method, the VCE is shipped to the customer site with a factory-default configuration. Prior to activation, the VCE contains no configuration or credentials to connect to the enterprise network.

Note: The Pull Activation section has been updated for the 3.3.0 release.

The Pull Edge activation process consists of the following steps:

  1. Send an Activation Email.

    The administrator initiates the activation process by sending an activation procedure email to the person that will install the Edge, typically a Site Contact.

  2. Activate the Edge Device.

    The individual following the instructions in the activation procedure email will activate the Edge device.

Complete the following instructions for the Pull Edge activation process.