Open Shortest Path First (OSPF) can be enabled only on a LAN interface as an active or passive interface. The Edge will only advertise the prefix associated with that LAN switch port. To get full OSPF functionality, you must use it in routed interfaces. Optionally, you can override the inherited Profile settings at the Edge level for OSPF.

If required, you can override the configuration for a specific Edge as follows:

  1. In the SD-WAN service of the Enterprise Portal, click Configure > Edges.
  2. Click the Device Icon next to an Edge, or click the link to an Edge and then click the Device tab.
  3. Go to the Routing & NAT section in the UI and click the arrow next to OSPF.
  4. In the OSPF Areas section, configure the Redistribution Settings for OSPFv2/v3, BGP Settings, and if applicable, Route Summarization.