Static Route Settings are useful for special cases in which static routes are needed for existing network attached devices (such as printers). You can add additional Static Route Settings (plus '+' icon) or delete Static Route Settings (minus '-' icon) located to the right of the dialog box. You can configure multiple static routes with different metrics, for the same network, on an Edge. However, only one static route is advertised to overlay for the network.
For details about the settings in the dialog box, refer to the table that follows.
To specify the Static Route Settings:
- Enter the subnet for the route.
- Enter the IP address for the route.
- Select the WAN interface where the Static Route will be bound.
- Select the Broadcast check box to advertise this route over VPN and allow other Edges in the network to have access to this resource.
- Optionally, add a description for the route.
