Configure Zscaler

This section describes Zscaler configuration.

Complete the following these steps on the Zscaler website. From there, you will create a Zscaler account, add VPN credentials, and add a location.

1. From the Zscaler website, create a Zscaler web security account.

   

2. Set up your VPN Credentials:
   1. At the top of the Zscaler screen, hover over the Administration option to display the drop down menu. (See image below).
   2. Under Resources, click VPN Credentials.

      

   3. Click Add VPN Credentials at the top left corner.

      

   4. From the Add VPN Credential dialog box:
      1. Choose FQDN as the Authentication Type.
      2. Type the User ID and Pre-Shared Key (PSK). You obtained this information from your Non SD-WAN Destination's dialog box in the SD-WAN Orchestrator.
      3. If necessary, type in any comments in the Comments section.

         

      4. Click Save.
3. Assign a location:
   1.  At the top of the Zscaler screen, hover over the Administration option to display the drop-down menu.
   2.  Under Resources, click Locations.
   3.  Click Add Location at the top left corner.
   4. In the Add Location dialog box (see image below): 
      1. Complete the text boxes in the Location area (Name, Country, State/Province, Time Zone).
      2. Choose None from the Public IP Addresses drop-down menu.
      3. In the VPN Credentials drop-down menu, select the credential you just created. (See image below).
      4. Click Done.
      5. Click Save.