To set up SD-WAN Orchestrator replication, perform the following steps:

  1. Click Replication from the Navigation panel to display the Orchestrator Replication screen.

    disaster-recovery-orchestrator-replication

  2. Enable the Standby Orchestrator by selecting the Standby (Replication Role) radio button.

    disaster-recovery-enable-for-standby-button

  3. Click the Enable for Standby button.

    The Orchestrator Success dialog box appears, indicating that the Orchestrator has been enabled for Standby, and that the Orchestrator will restart in Standby mode.

    disaster-recovery-standby-mode-success-dialog-box

  4. Click OK.

    disaster-recovery-standby-orchestrator

    After the Standby Orchestrator has been configured for replication, configure the Active Orchestrator according to the instructions below.