At the Edge level, you can override the Address Resolution Protocol (ARP) Timeout settings inherited from a Profile by selecting the Override check box.
To override the ARP timeouts values at the Edge-level, perform the following steps:
Procedure
- In the SD-WAN service of the Enterprise portal, go to Configure > Edges. The Edges page displays the existing Edges.
- Click the link to an Edge you want to override L2 settings or click the View link in the Device column of the Edge.
The
Device tab displays the configuration options for the selected Edge.
- Under the Connectivity category, click ARP Timeouts and select the Override check box.
- Select the Override default ARP Timeouts check box and then override the various ARP timeouts inherited from the Profile as follows:
Field |
Description |
ARP Stale Timeout |
The allowable value ranges from 1 minute to 23 hours and 58 minutes. |
ARP Dead Timeout |
The allowable value ranges from 2 minutes to 23 hours and 59 minutes. |
ARP Cleanup Timeout |
The allowable value ranges from 3 minutes to 24 hours. |
Note: To set the default ARP timeout values at the Edge level, unselect the
Override default ARP Timeouts checkbox.
- Click Save Changes.