To set up disaster recovery in the SASE Orchestrator:
- Install a new SASE Orchestrator whose version matches the version of the VMware that is currently the Active SASE Orchestrator.
- Set the following properties on the Active and Standby SASE Orchestrator, if necessary.
vco.disasterRecovery.transientErrorToleranceSecs
to a non-zero value (Defaults to 900 seconds in version 3.3 and later, zero in earlier versions). This prevents any transient errors from resulting in an Edge/Gateway management plane update.vco.disasterRecovery.mysqlExpireLogsDays
(Defaults to 1 day). This is the amount of time the Active SASE Orchestrator keeps the mysql binlog data.
- Set up the
network.public.address
property on the Active and Standby to the address contacted by the Edges (Heartbeats). - Set up DR by following the usual DR Setup procedure that is described in SASE Orchestrator Disaster Recovery.