Run this test to list the IPv6 prefixes received by the Edge from the BGPv6 neighbor before applying the BGPv6 neighbor inbound filters configured in the Orchestrator.
When Can You Run This Test
Run this test to check and confirm that all the prefixes are received by the Edge from a BGPv6 neighbor. For instructions, see Run Remote Diagnostic Tests on Edges.
What to Check in the Test Output
Run the
Show BGPv6 Neighbor Received Routes test on the required Edge. Following is an example of the test output:
Verify the following in the output:
The output must display the total number of prefixes received by the Edge.
The output must list the number of BGPv6 prefixes filtered by the inbound filters.
The Edge must list all the received prefixes.
If a BGPv6 prefix is not present in the table, check the BGPv6 neighborship status and also check the list of BGPv6 prefixes advertised by the peer BGP on the neighbor device.
