What is the Purpose of This Test

Run this test to list the entire BGP routes. Use IPv4 or IPv6 prefix to filter specific BGP routes or leave the prefix empty to see all the routes.

When Can You Run This Test

Run this test to check and confirm:
  • If a prefix is received in the BGP Table.
  • If a BGP prefix is allowed to redistribute into the SD-WAN overlay route table.

For instructions, see Run Remote Diagnostic Tests on Edges.

What to Check in the Test Output

Run the List BGP Routes test on the required Edge. Following is an example of the test output:

Verify the following in the output:
  • BGP routes received from BGP neighbors must be present in the table.
  • The BGP route must have the advertise flag set to True, and the reachable flag set to Yes, to redistribute the received prefix into the overlay route table.
  • The BGP route must be tagged with the expected Metric Type, Next Hop IP address, exit Interface, Segment Name, and Community Tag.