Open Shortest Path First (OSPF) can be enabled only on a LAN interface as an active or passive interface. The Edge will only advertise the prefix associated with that LAN switch port. To get full OSPF functionality, you must use it in routed interfaces. After you configure the OSPF settings at the Profile level, all the Edges associated with the Profile will inherit the OSPF configuration from the Profile. However, you cannot override the OSPF configuration settings at the Edge level.

If needed, you can view the OSPF configuration for a specific Edge as follows:

  1. In the SD-WAN service of the Enterprise Portal, click Configure > Edges.
  2. Click the Device Icon next to an Edge, or click the link to an Edge and then click the Device tab.
  3. Go to the Routing & NAT section and click the arrow next to OSPF.
  4. In the OSPF section, you can view all the inherited OSPF configuration such as OSPF areas, Redistribution settings for OSPFv2/v3, BGP settings, and Route Summarization.