To set up SASE Orchestrator replication, perform the following steps:

  1. Click Replication from the Navigation panel to display the Orchestrator Replication screen.Orchestrator Replication screen - The Standby radio button begins the replication process.
  2. Enable the Standby Orchestrator by selecting the Standby (Replication Role) radio button.Clicking the Enable for Standby button begins to prepare the Orchestrator for the Standby role.
  3. Click the Enable for Standby button.

    The Prepare this Orchestrator for Standby Role dialog displays.

    Enable for Standby dialog

  4. Click the Enable for Standby button again.

    The Orchestrator Success message displays across the top of the screen indicating that the Orchestrator has been enabled for Standby, and that the Orchestrator will restart in Standby mode.

  5. Click OK.
    The Orchestrator Address and the Orchestrator Uuid number are required to activate the Active Orchestrator.

    After the Standby Orchestrator has been configured for replication, configure the Active Orchestrator according to the instructions below.