What is the Purpose of This Test
VPN Test command is used to view the VPN Branch to Branch Connectivity between the Edges.
When Can You Run This Test
Run this test if the data traffic between the Branches or between Hub and Spoke are not bi-directional.
For instructions on how to run a remote diagnostic test on Edges, see Run Remote Diagnostic Tests on Edges.
What to Check in the Test Output
Following is an example of the test output:
This Remote Diagnostics test will perform the VPN test by confirming the tunnel status between the Edges, and the output displays the following information:
| Field | Description |
|---|---|
| Edge Name | Specifies the name of the peer Edge. |
| Destination | Specifies the logical ID of the destination device. |
| Result | The result displays one of the following:
|
| Latency (milliseconds) | Specifies the latency in milli seconds. |
