Note:
Before you can run a silent installation, you must create a configuration file that the installer uses to complete your installation.
To create a configuration file, follow these steps:
| Step |
Action |
| 1 |
Copy the sample configuration file from the distribution (silent-install.properties) to a directory on the server where you are installing Network Configuration Manager. |
| 2 |
Use the vi command to modify this file. |
| 3 |
Define each of the properties in this file for your server type, according to the table below.
Note:
Errors occur during installation if all required properties do not contain a value. |
| 4 |
Save your changes to the file. You are now ready to install Network Configuration Manager in silent mode. |
