Procedure to configure the IP Availability Manager built-in trap receiver

To configure the IP Availability Manager built-in trap receiver:

1. Go to the BASEDIR/smarts/bin directory in the IP Manager installation area and type the following command to open the trapd.conf file:

                  sm_edit conf/trapd/trapd.conf
               

2. Set the port number of the following PORT entry to the destination port specified for IP Availability Manager in the trap exploder’s trapd.conf file:

                  PORT: 
                  <port number>
               

3. Save and close the file.

   The modified version of the trapd.conf file is saved to the BASEDIR/smarts/local/conf/trapd directory in the IP Manager installation area.

4. If IP Availability Manager was running before you edited the trapd.conf file, restart IP Availability Manager.