When you install a 10.1.0 product, FIPS 140 is not enabled by default. You must enable FIPS 140 on a clean installation or an upgrade, before the servers are started, using the following procedure:

  1. Back up the imk.dat, brokerConnect.conf, serverConnect.conf and clientConnect.conf files from the existing installation. These files are located in the BASEDIR/local/conf folder.

    Note:

    The backup is necessary in case you need to disable FIPS 140 mode and remove FIPS 140-2 encryption.

  2. Run the following command at the command line prompt:

                   sm_rebond --upgrade --basedir=<
                   BASEDIR
                   >/smarts
                   
                   sm_rebond --upgrade --basedir=C:\InCharge\SAM\smarts
                
  3. When prompted, type a password to regenerate the imk.dat file. The default password is Not a secret.

  4. Set the value for the parameter SM_FIPS140 to TRUE in the runcmd_env.sh file. The file is located under the BASEDIR/smarts/local/conf directory.