Enabling FIPS 140 mode on SAM Dashboard

1. Perform steps 1 - 3 as described in the section, “Enabling FIPS 140 mode on a new installation” on page 35.

2. Set the value for the com.smarts.fips_mode to TRUE in the corresponding webconsole.properties file (located under <BASEDIR>/InCharge/CONSOLE/smarts/tomcat/webapps/webconsole folder)

   or

   dashboard.properties file (located under <BASEDIR>/InCharge/CONSOLE/smarts/tomcat/webapps/templates).

3. Set the value for the parameter SM_FIPS140 to TRUE in the runcmd_env.sh file. This file is located under the <BASEDIR>/CONSOLE/smarts/local/conf folder of your Global Console installation.

   or

   Use "-Dcom.smarts.fips_mode=true" as a command line parameter for the sm_gui command.