Adding node names for CDR monitoring

With this procedure, you can configure the AVAYA device to send data to the M&R instance where the is installed.

Follow these steps to add a new node for CDR monitoring. Make sure you have login credentials with proper administrative rights to make this configuration.

Procedure

1. Use an SSH client to open a terminal and connect to the ACM (Aura Communication Manager).
   1. Type: ssh <username>@<ACM FQDN> and then press Enter.
   2. Enter password.
   3. Enter terminal type: vt100.
   4. At the prompt, enter sat.
   5. Enter terminal type: W2KTT.
2. Execute this command: change node-names ip.

   change node-names ip                                         Page 1 of 2
                                IP NODE NAMES
       Name               IP Address            Name             IP Address
   clan1                 10.1.10.21
   clan2                 10.1.10.22
   default               0.0.0.0
   medpro1               10.1.10.31
   medpro2               10.1.10.32
   procr                 10.1.10.9
   vall                  10.1.10.41
   prognosis             10.1.10.105  	
   

3. Complete the following fields: Name: Add a name, then IP Address: Add the IP address of the host where Watch4net is running.
4. Press Esc + e to save and exit.

Example

NAT Environment: In the case of a NAT environment the IP Address should be set to the Public IP address assigned to the IP Telephony Manager Monitoring server.

Note: If the PBX has an S85xx or S87xx series Media Server, then ensure that a valid node name for the CLAN board exists as well. If it has an S8300 series Media Server, then ensure that a valid node name for the PROCR also exists.