The following existing device issues have been discovered with other releases. A resolution is included to address the issue, if available.
Juniper EX2500 Switch - Not Supported with Juniper Switch (EX Series) Driver
Juniper EX2500 models are not supported by the Juniper Switch (EX Series) device driver. Use the Juniper EX2500 Switch driver for EX2500 model support.
Separate Push and Commit Operations
Previously, this driver had separate push and commit operations. Currently this is reversed, and all pushes will be committed (or rolled back) automatically at the end of the push.
A rollback 0 command is issued after entering global config mode, but before sending any commands.
Any time the driver fails to commit changes, a rollback 0 command is issued before exiting configuration mode.
When managing a stack of EX4200s, the system properties and hardware are shown for the primary switch only.
Configlets may contain config mode command-line interface commands, such as:
set snmp contact EMCcontact
set snmp location EMClocation
or formatted config snippets, such as:
but must not contain both formats.