Creating the configuration file for a silent installation

Note:

Before you can run a silent installation, you must create a configuration file that the installer uses to complete your installation.

To create a configuration file, follow these steps:

Step	Action
1	Copy the sample configuration file from the distribution (silent-install.properties) to a directory on the server where you are installing Network Configuration Manager.
2	Use the vi command to modify this file.
3	Define each of the properties in this file for your server type, according to the table below. Note: Errors occur during installation if all required properties do not contain a value.
4	Save your changes to the file. You are now ready to install Network Configuration Manager in silent mode.