Known issues

The following existing device issues have been discovered with other releases. A resolution is included to address the issue, if available.

Juniper EX2500 Switch - Not Supported with Juniper Switch (EX Series) Driver

• Juniper EX2500 models are not supported by the Juniper Switch (EX Series) device driver. Use the Juniper EX2500 Switch driver for EX2500 model support.

  Separate Push and Commit Operations

• Previously, this driver had separate push and commit operations. Currently this is reversed, and all pushes will be committed (or rolled back) automatically at the end of the push.

  Rollback Command

• A rollback 0 command is issued after entering global config mode, but before sending any commands.

• Any time the driver fails to commit changes, a rollback 0 command is issued before exiting configuration mode.

  Juniper EX

• When managing a stack of EX4200s, the system properties and hardware are shown for the primary switch only.

• Configlets may contain config mode command-line interface commands, such as:

  set snmp contact EMCcontact

  set snmp location EMClocation

  or formatted config snippets, such as:

  snmp

  {

  contact EMCcontact

  location EMClocation

  }

  but must not contain both formats.