Enabling trunk groups for CDR monitoring

Enabling trunk groups is not required for configuring the SolutionPack, however if you do not configure them you will not get trunk group-related traffic statistics.

For each trunk group where CDR records are required, verify that CDR reporting is enabled.

Procedure

1. Execute the command: change trunk-group <n> (where <n> is the trunk group number.

   change trunk-group 1                                           Page 1 of 21
                                   TRUNK GROUP
   Group Number: 1                 Group Type: isdn            CDR Reports: y
     Group Name: Bondi H.323              COR: 1     TN: 1           TAC: 501
      Direction: two-way     Outgoing Display? y       Carrier Medium: H.323
    Dial Access? n             Busy Threshold: 255     Night Service:
   Queue Length: 0
   Service Type: tie                Auth Code? n       TestCall ITC: rest
                        Far End Test Line No:
   TestCall BCC: 4
   

2. Make sure that the CDR Reports field is set to y.
3. Repeat for all trunk groups to be reported.