Configurations to use the Precision Time Protocol (PTP).
You can configure the PTP in VMware Telco Cloud Automation in two modes:
PTP in Passthrough mode.
PTP over virtual function (VF) mode.
PTP in Passthrough Mode
VMware Telco Cloud Automation supports PTP in Passthrough mode on XXV710 and E810 cards. To use PTP in Passthrough mode, set Device Type to NIC when configuring the PTP using Infrastructure Designer. For details, see Infrastructure Requirements Designer.
The diagram shows how the PTP works in the passthrough mode.
Figure 1. PTP in Passthrough Mode
Note:
For XXV710 card, you can use any Physical Function (PF) port for PTP.
For E810 card, you can use only Physical Function 0 (PF0) port for PTP.
PTP over VF Mode
VMware Telco Cloud Automation supports PTP over VF only for Intel E810 NICs. You can use any port of the E810 card for PTP over VF.
The diagram shows how the PTP over VF works.
Figure 2. PTP over VF
You can create a host profile to use the PTP over VF. For details, see
Add a Host Profile.
Note: Before you create the host profile for PTP over VF, ensure that you use a PTP-enabled port connected to PTP-enabled switch.
Creating a host profile enables you to control VF assignment from PF for a PTP.
For PTP over VF, the default VF assignment can happen from any of the SRIOV-enabled PFs.