This procedure explains how to configure NSX-T logical networking with standard mode.
Procedure
- Configure the following NSX-T components:
- Transport Zones (Std Overlay and Std VLAN). See Create Transport Zones.
- IP Pools for TEP. See Create an IP Pool for Tunnel End Points IP Addresses.
- Transport Node Profile. See Add a Transport Node Profile.
- Uplink profiles. See Create Uplink Profiles.
- Configure NSX for Resource Cluster ESXi hosts. See Configure a Managed Host Transport Node.
- Deploy and configure the NSX-T Edge Transport node. See Create an NSX Edge Transport Node.
- Configure NSX-T Edge Cluster. See Create an NSX Edge Cluster.
- (Optional) Install and Configure a Bare Metal Edge.
- Create NSX-T segments. See the NSX-T Data Center Administration Guide.
- Create and configure Logical Routers.
While creating and configuring logical routers, consider the following:
Create Tier-0 Router and configure the uplink interface.
Configure BGP peering with TOR switch and enable Route Redistribution.
Create Tier-1 Router and attach it to Tier-0 Router.
Configure Downlink interfaces on Tier-1 Router for the segments.
Configure Route Redistribution on the Tier-1 Router.