Default LSP ping command line for Cisco devices

By default, for Cisco devices, the MPLS Topology Server includes the following command options in the LSP ping command lines that it constructs and invokes for LSP ping server tool invocations:

         ping mpls ipv4 <destination-address destination-mask> [repeat 5] 
   [timeout 2] [size 100] [interval 0]

Here is an example of an LSP ping command line and the ping test results. The remote computer shell prompt “Router#” indicates that the MPLS Topology Server has established a Telnet, SSH1, or SSH2 session with the originating device.

dev-VPLS5#ping mpls ipv4 10.9.7.9 255.255.255.255 repeat 5 timeout 2 size 100 interval 0
Sending 5, 100-byte MPLS Echos to 10.9.7.9/32, 
     timeout is 2 seconds, send interval is 0 msec:
Codes: '!' - success, 'Q' - request not sent, '.' - timeout,
  'L' - labeled output interface, 'B' - unlabeled output interface, 
  'D' - DS Map mismatch, 'F' - no FEC mapping, 'f' - FEC mismatch,
  'M' - malformed request, 'm' - unsupported tlvs, 'N' - no label entry, 
  'P' - no rx intf label prot, 'p' - premature termination of LSP, 
  'R' - transit router, 'I' - unknown upstream index,
  'X' - unknown return code, 'x' - return code 0
Type escape sequence to stop.
QQQQQ
Success rate is 0 percent (0/5)