Procedure to configure the Network Protocol Manager built-in trap receiver

To configure the Network Protocol Manager built-in trap receiver:

1. Go to the BASEDIR/smarts/bin directory in the Network Protocol Manager installation area and type the following command to open the bgp.conf or ospf.conf file:

                  sm_edit conf/bgp/bgp.conf
   -or-
   sm_edit conf/ospf/ospf.conf
               

2. Find the following line:

   TrapPort = 0
   

3. Set the port number (0) to the destination port specified for Network Protocol Manager for BGP or Network Protocol Manager for OSPF in the trap exploder’s trapd.conf file.

   A valid port number is 162 or any value in the range 2049 to 65534 inclusive.

4. Save and close the file.

   The modified version of the bgp.conf file is saved to the BASEDIR/smarts/local/conf/bgp directory, or the modified version of the ospf.conf file is saved to the BASEDIR/smarts/local/conf/ospf directory.

5. If Network Protocol Manager was running before you edited the bgp.conf or ospf.conf file, restart Network Protocol Manager.