After the initial boot, use the ESXi Direct Console User Interface (DCUI) for initial host network configuration and administrative access.

Perform the following tasks to configure the host network settings:

  • Configure the network adapter (vmk0) and VLAN ID for the Management Network.

  • Configure the IP address, subnet mask, gateway, DNS server, and FQDN for the ESXi host.

Repeat this procedure for all hosts in the ROBO consolidated cluster. Enter the respective values from the prerequisites section for each host that you configure. See Prerequisites for Installation of ESXi Hosts in ROBO.

Procedure

  1. Open the DCUI on the physical ESXi host nyc01r01esx01.rainpole.local.
    1. Open a console window to the host.
    2. Press F2 to enter the DCUI.
    3. Log in using the following credentials.

      Setting

      Value

      User name

      root

      Password

      esxi_root_user_password

  2. Configure the network.
    1. Select Configure Management Network and press Enter.
    2. Select VLAN (Optional) and press Enter.
    3. Enter 1811 as the VLAN ID for the Management Network and press Enter.
    4. Select IPv4 Configuration and press Enter.
    5. Configure the IPv4 network using the following settings and press Enter.

      Setting

      Value

      Set static IPv4 address and network configuration

      Selected

      IPv4 Address

      172.18.11.101

      Subnet Mask

      255.255.255.0

      Default Gateway

      172.18.11.253

    6. Select DNS Configuration and press Enter. 
    7. Configure DNS by using the following settings and press Enter.

      Setting

      Value

      Use the following DNS Server address and hostname

      Selected

      Primary DNS Server

      172.18.11.4

      Alternate DNS Server

      172.16.11.4

      Hostname

      nyc01r01esx01.rainpole.local

    8. Select Custom DNS Suffixes and press Enter.
    9. Ensure that there are no suffixes listed and press Enter.
  3. After you configure all host network settings, press Escape to exit and press Y to confirm the changes.
  4. Repeat this procedure for all hosts.