After the initial boot, use the ESXi Direct Console User Interface (DCUI) for the initial host network configuration and administrative access.

Perform the following tasks to configure the host network settings.
  • Configure the network adapter (vmk0) and VLAN ID for the Management Network.
  • Configure the IP address, subnet mask, gateway, DNS server, and FQDN for the ESXi host.
Repeat this procedure for all ESXi hosts in Availability Zone 2. Enter the respective values from the prerequisites section for each host that you configure. See Prerequisites for Installation of ESXi Hosts for Availability Zone 2.

Procedure

  1. Open the DCUI on the sfo02m01esx01 physical ESXi host.
    1. Open a console window to the host.
    2. Press F2 to enter the DCUI.
    3. Log in using the following credentials.
      Setting Value
      User name root
      Password vsan_witness_root_password
  2. Configure the host network.
    1. Select Configure management network and press Enter.
    2. Select VLAN (Optional) and press Enter.
    3. Enter 1621 as the VLAN ID for the Management Network and press Enter.
    4. Select IPv4 Configuration and press Enter.
    5. Configure IPv4 network using the following settings, and press Enter.
      Setting Value
      Set static IPv4 address and network configuration Selected
      IPv4 Address 172.16.21.101
      Subnet Mask 255.255.255.0
      Default Gateway 172.16.21.253
    6. Select DNS Configuration and press Enter. 
    7. Configure the following DNS settings, and press Enter.
      Setting Value
      Use the following DNS Server address and hostname. Selected
      Primary DNS Server 172.16.11.5
      Alternate DNS Server 172.16.11.4
      Hostname sfo02m01esx01.sfo01.rainpole.local
    8. Select Custom DNS Suffixes and press Enter.
    9. Ensure that there are no suffixes listed, and press Enter.
  3. Press Esc to exit and press Y to confirm the changes.
  4. Repeat this procedure for the remaining hosts in Availability Zone 2.